A Study of Minimal Quantity Lubrication with MWCNTs In Turning of AISI 304L steel | Faculty Open Information System

A Study of Minimal Quantity Lubrication with MWCNTs In Turning of AISI 304L steel

in Sciences Citation Index(SCI), 科學引文索引資料庫(SCI)
標題A Study of Minimal Quantity Lubrication with MWCNTs In Turning of AISI 304L steel
出版類型SCI(Sciences Citation Index)
出版年度2014
AuthorsHUANG WEI TAI, 黃惟泰, Hsun Heng Tsai 蔡循恒, Der Ho Wu 吳德和, & Wei-Tai Lee 李威泰
開始頁108
頁數6
出版日期2014 / 8
其他編號0000
中文摘要

This paper proposes a new lubricant environment when MWCNTs was used in MQL for AISI 304L in the turning machine. The effects of dry cutting, MQL cutting, and MWCNTs/MQL were compared to the surface roughness of work pieces, cutting temperature and the tool wear. In the past, the studies have shown that the MQL process can prolong tool life and improve surface accuracy in machining. The purpose of using MWCNTs suspensions is to increase the thermal conductivity of cutting fluid and to reduce the temperature during the cutting and decrease the thermal wear of tool simultaneously. The present study investigated the characterization of the MWCNTs was applied into MQL during the turning process of AISI 304L experimentally. The results showed that the MWCNTs will be a very good additive to MQL, not only with the benefits of improving surface roughness but also with ability of prolonging life of tool by reducing the cutting temperature in turning AISI 304L.

期刊名稱Key Engineering Materials
校址:912 屏東縣內埔鄉學府路1號 總機:886-8-7703202 傳真:886-8-7740165 系統開發統維護單位:國立屏東科技大學 電算中心 版權所有