Stainless Steel Tube-Based Cell Cryopreservation Containers

in Sciences Citation Index(SCI), 科學引文索引資料庫(SCI)
標題Stainless Steel Tube-Based Cell Cryopreservation Containers
出版類型SCI(Sciences Citation Index)
出版年度2013
AuthorsWei Hung Shih, 施威宏, Zong Yan Yu 余宗晏, & Wei Te Wu(Benny) 吳瑋特
開始頁280
頁數6
出版日期2013 / 11
其他編號0000
中文摘要

This study focused on increasing the freezing rate in cell vitrification cryopreservation by using a cryopreservation container possessing rigid mechanical properties and high heat-transfer efficiency. Applying a fast freezing rate in vitrification cryopreservation causes a rapid temperature change in the cryopreservation container and has a substantial impact on mechanical properties; therefore, a highly rigid cryopreservation container that possesses a fast freezing rate must be developed. To produce a highly rigid cryopreservation container possessing superior heat transfer efficiency, this study applies an electrochemical machining (ECM) method to an ANSI 316L stainless steel tube to treat the surface material by polishing and roughening, thereby increasing the freezing rate and reducing the probability of ice crystal formation. The results indicated that the ECM method provided high-quality surface treatment of the stainless steel tube. This method can reduce internal surface roughness in the stainless steel tube, thereby reducing the probability of ice crystal formation, and increase external surface roughness, consequently raising convection heat-transfer efficiency. In addition, by thinning the stainless steel tube, this method reduces heat capacity and thermal resistance, thereby increasing the freezing rate. The freezing rate (3399 ± 197 °C/min) of a stainless steel tube after interior and exterior polishing and exterior etching by applying ECM compared with the freezing rate (1818 ± 54 °C/min) of an original stainless steel tube was increased by 87%, which also exceeds the freezing rate (2015 ± 49 °C/min) of an original quartz tube that has a 20% lower heat capacity. However, the results indicated that increasing heat-transferring surface areas and reducing heat capacities cannot effectively increase the freezing rate of a stainless steel tube if only one method is applied; instead, both techniques must be implemented concurrently to improve the freezing rate.

網址http://www.sciencedirect.com/science/article/pii/S0011224013002046
期刊名稱Cryobiology
校址:912 屏東縣內埔鄉學府路1號 總機:886-8-7703202 傳真:886-8-7740165 系統開發統維護單位:國立屏東科技大學 電算中心 版權所有